Wolf Range

Wolf GR606DG

Model # GR606DG

Wolf built the GR606DG as a 60-inch range with six open burners alongside an infrared dual griddle, and unlike the Dual Fuel line it keeps gas on both sides of the appliance — the oven cavity is heated by a gas burner and regulated by an oven thermostat rather than by an electric element and a solid-state sensor.

When a burner on the GR606DG clicks without lighting, the usual short list is a dirty or cracked electrode, a burner base sitting slightly out of position, a failed micro-switch at that burner’s valve, or a spark module on its way out. Wolf’s own service documentation for this generation walks through exactly that sequence. The dual griddle doubles the heated plate area and runs on two independently controlled infrared burners, so one half going cold while the other stays hot is a normal symptom pattern and a useful one to report.

The designation itself is most of the spec sheet: GR for Gas Range, 60 for the cabinet width in inches, 6 for the six open burners and DG for the infrared dual griddle.

Key Features

  • 60-inch all-gas range: six open burners alongside an infrared dual griddle, with a gas oven below
  • Spark module and per-burner electrodes for surface ignition
  • Gas oven burner regulated by an oven thermostat rather than an electronic sensor
  • Separate dual griddle assembly with its own burner and control

Most Common Issues on This Model

01

Surface burner will not light, or keeps sparking after it has lit

02

Gas oven bakes consistently above or below the set temperature

03

Oven burner will not ignite at all

04

Persistent gas smell near the range — a safety call, not a routine repair

05

Dual griddle will not heat, or heats unevenly across its surface

Error Codes Common to This Model

Own This Model? Book a Diagnosis.

Have the model number to hand when you book, so the technician arrives knowing which parts this model uses and where it usually fails.

FAQ

Wolf GR606DG FAQ

Continuous sparking after ignition is one of the best-documented faults on this range generation. It usually comes down to the micro-switch at that burner valve, a burner base rotated slightly out of position, or a damaged electrode wire — all serviceable without replacing the burner.

The dual griddle runs two independently controlled infrared burners, so one half going cold is a single-burner fault rather than a whole-griddle failure, which keeps the repair narrow.

Need a repair? We're ready to help. Call Now
Call Us Schedule